Appendix A Installation
Configuration
If you are not familiar with the Setup Display of the control console, you
may wish to refer to
proceeding. Also refer to
switch active monitors.
To configure the operation of the Secondary Video option:
Procedure:
1. Press [SETUP]
2. Press [22]
3. Press [ENTER]
4. Using the up/down arrow keys to
select mode (see Monitor Modes below)
5. Press [ENTER]
Monitor Modes
Disabled: Use this selection when you are using only one monitor.
Auto Switch: Use this selection to activate the secondary video display
and to allow "Automatic" switching between displays when a display key is
pressed.
Man Switch: Use this selection to activate the secondary video display and
to disallow "Automatic" switching between displays when a display key is
pressed. Moving between video displays must be set by the Trackball or the
(MONITR) soft-key.
Fixed mode: This mode has eight settings corresponding to the eight
primary displays for the console. The eight settings are:
Fixed Stage
Fixed Device
Fixed Track
Fixed Patch
Page 228
Chapters 12 System Settings
Chapter 2 Displays
Fixed Preview
Fixed Cuesht
Fixed Playbk
Fixed Setup
for an overview before
for information on how to
Notes:
Opens Setup display
Menu Item 22: Disabled
Rev. 1.30.03.07.r1