Using Effects - Leviton 600 User Manual

Chapter 10 Automated Devices
Using Groups as Focus Points
Sometimes the venue changes or there are other changes in the show
which demand re-focusing of certain pan and tilt positions. These new
positions can be quickly updated in your cues, subs and effects by first
recording your focus points into groups then assigning these groups to your
cues, subs or effects. This way, whenever the group is updated, any cue,
sub or effect which references that group will be automatically updated
also.
Follow below to program a group with a pan/tilt position using device one
and assign it to cue 1:
Procedure:
1. Press [DEVICE] [1] [ENTER]
2. Press [DEFAULT] key next to LCD
3. Press (RelAll)
4. Position the device as needed
using the trackball
5. Press [RECORD GROUP] [#] [ENTER]
6. Press (RelAll) (Optional)
7. Press [CUE][1][GROUP][1][ENTER] Assigns group 1 to cue 1
Groups can also be assigned to a cue as the cue is being recorded: press
[RECORD CUE] [#] [GROUP] [#] [ENTER].

Using Effects

Effects can also be used to control automated devices. The Effects display
is set up to allow the user to input device traits, submasters, groups, cues
and channels into effect elements of which there are 10 per effect step.
Please see
Page 164
Chapter 7 Effects
for more information on using effects.
Notes:
Selects Device 1 and displays
it on the LCD display
This will position the device in
the middle of its pan and tilt,
open the shutter, and bring
the dimmer to full
Releases all traits so they
will not be recorded (gray)
Activates just the pan/tilt traits
for record (white)
Group is recorded with
the pan/tilt traits of device 1
Releases all traits to prevent
recording into further cues.
Rev. 1.30.03.07.r1