Mitsubishi Electric NZ2GF2B-60TCTT4 User Manual page 91

DIN rail
stopper
DIN rail
stopper
Remark
Do not slide modules from the edge of the DIN rail when mounting them. Doing so may damage the metal part located on the
back of the module.
(1) Removal procedure
6.
Slide the DIN rail stopper up to the left side of the
module.
7.
Hold the DIN rail stopper in the direction opposite to
the arrow on the stopper and tighten the screw with
a screwdriver.
8.
In the same procedure, install the DIN rail stopper
DIN rail
on the right side of the module again.
stopper
For the right side installation, note that the direction of
the stopper is upside down.
1.
Remove the DIN rail stoppers.
Follow the reverse procedure of the installation.
2.
While pushing down on the DIN rail hook with a
flathead screwdriver, draw the lower part of the
module and remove it from the DIN rail.
CHAPTER 6 INSTALLATION AND WIRING
6
89