Mitsubishi Electric NZ2GF2B-60TCTT4 User Manual page 83

(2) When the module is used as a temperature control module
Check box
Station number setting
Set a station number for a temperature control module.
Mount the temperature control module to a DIN rail.
Connect the temperature control module to a power supply,
Ethernet cables, and external devices.
Parameter settings and programming
Set parameters and create a program.
Auto tuning execution
Set PID constants using the auto tuning function.
Warm-up operation
(when the NZ2GF2B-60TCTT4 is used)
Perform a warm-up operation for about 15 minutes before starting
an operation.
● A proper performance of temperature compensation is required for the NZ2GF2B-60TCTT4 which uses a thermocouple
for the temperature sensors. Perform warm-up operation about 15 minutes before starting operation.
● To replace the module, follow the procedure described below.
• Turn off the power of the module and remove the temperature control module.
• Prepare a new temperature control module and follow the above procedure from "Setting a station number" to
"Parameter settings and programming". (The network parameter of the master station does not need to be set
again.)
• After checking the operation, restart the control.
Connection
Wiring
CHAPTER 4 PROCEDURES BEFORE OPERATION
For details on the setting of station numbers, refer to
the following.
• Page 85, Section 6.1
For details on the mounting, refer to the following.
• Page 86, Section 6.2
• Page 88, Section 6.3
For details on the wiring, refer to the following.
• Page 91, Section 6.4
• Page 93, Section 6.5
• Page 96, Section 6.6
For details on the execution of auto tuning, refer to
the following.
• Page 159, Section 8.3.7
For details on the parameter settings and
programming, refer to the following.
• Page 108, Section 7.1
• Page 120, Section 7.2
• Page 232, CHAPTER 9
4
81