Mitsubishi Electric NZ2GF2B-60TCTT4 User Manual page 81

*1 The default value depends on the mode used. For details on the default value, refer to the following.
Page 309, Appendix 3
*2 This column indicates whether data can be read from or written to the remote buffer memory area through sequence
programs.
R: Reading enabled
W: Writing enabled
*3 This column indicates whether the setting in the remote buffer memory area is automatically changed when the input
range is changed. For details, refer to the following.
Page 135, Section 8.1.6
*4 This column indicates whether data can be written to the non-volatile memory by turning off and on Set value backup
instruction (RY15). For details, refer to the following.
Page 136, Section 8.1.7
*5 This column indicates whether or not the setting can be changed by turning off and on During operation setting change
instruction (RY10). For details, refer to the following.
Page 295, Appendix 1.2 (3)
*6 This column indicates whether or not the setting can be changed by turning off and on Initial data setting request flag
(RY9) when all channels stop. For details, refer to the following.
Page 295, Appendix 1.2 (1)
*7 Available only under the mix control (expanded mode). With other models, this area is handled as a system area.
*8 Available only under the heating-cooling control (expanded mode). With other models, this area is handled as a system
area.
CHAPTER 3 SPECIFICATIONS
79
3