Mitsubishi Electric NZ2GF2B-60TCTT4 User Manual page 362

(64)MAN mode (address: 601H)
This area is for checking completion of the mode shift when shifting AUTO (auto) mode to MAN (manual) mode.
The following values are stored in this remote buffer memory area.
• 0: MAN mode shift uncompleted
• 1: MAN mode shift completed
The following figure shows bits of the remote buffer memory area that correspond to each channel.
When shift to MAN mode is completed, bits corresponding to appropriate channel become MAN mode shift
completed (1).
(a) How to shift the mode
Shift the mode by the following remote buffer memory area.
• CH AUTO/MAN mode shift (address: 113H, 143H, 173H, 1A3H) (Page 332, Appendix 3 (22))
(b) Setting manipulated value (MV) in MAN mode
Set the manipulated value (MV) in the following remote buffer memory area.
• CH MAN output setting (address: 114H, 144H, 174H, 1A4H) (Page 333, Appendix 3 (23))
Set the manipulated value (MV) after confirming MAN mode (address: 601H) has become MAN mode shift
completed (1).
(65)Control switching monitor (address: 602H)
The value set in Control mode shift (address: 80H) is stored. The mode in operation can be confirmed.
The following table lists the stored values and the contents.
Stored value
0H
1H
2H
3H
4H
100H
Select a mode with Control mode shift (address: 80H).
For details, refer to the following.
Page 311, Appendix 3 (3)
For details on the modes, refer to the following.
Page 138, Section 8.2, Page 145, Section 8.3.1
360
Standard
b15 b14 b13 b12 b11 b10
0 0 0 0 0 0
Bit data from b4 to b15 are fixed to 0.
Temperature control mode
Temperature input mode
Heating-cooling
b9 b8 b7 b6 b5 b4 b3
0 0 0 0 0 0 CH4
Common
Control mode
Standard Control
Heating-cooling control (normal mode)
Heating-cooling control (expanded mode)
Mix control (normal mode)
Mix control (expanded mode)
b2 b1 b0
CH3 CH2 CH1