Mitsubishi Electric NZ2GF2B-60TCTT4 User Manual page 114

Set all the items for the parameter. If any blank exists, the parameter cannot be written to the temperature control module.
10.
Double-click the item to change, and set a new value.
• Items to be set from the pull-down list
Double-click the item to display the pull-down list, and select the value from the list.
• Items to be entered in the text box
Double-click the item and enter a value.
The list cannot be collapsed.
The checkbox cannot be unchecked.
Enter a value in the text box.
Select an item from the pull-down list.
Function extension and sampling cycle
selection
Cyclic data update watch time setting
Control mode switching
HOLD_CLEAR setting
● When "Control mode switching" is changed and the parameter write is performed, remote buffer memory areas (address
of 100H or later) are overwritten with default values.
● When "Control output cycle unit switching setting" is changed and the parameter write is performed, the following
parameters are overwritten with default values.
• "Control output cycle setting"
• "Heating control output cycle setting"
• "Cooling control output cycle setting"
● When "Sampling cycle selection" is changed and the parameter write is performed, remote buffer memory areas
(address of 100H or later) are overwritten with default values.
112
Setting item
Auto-setting at input range change
Setting change rate limiter setting
Control output cycle unit switching setting
Moving averaging process setting
Sampling cycle selection
CH_HOLD_CLEAR setting
Reference
Page 309, Appendix 3 (1) (a)
Page 310, Appendix 3 (1) (b)
Page 310, Appendix 3 (1) (c)
Page 310, Appendix 3 (1) (d)
Page 310, Appendix 3 (1) (e)
Page 311, Appendix 3 (2)
Page 311, Appendix 3 (3)
Page 312, Appendix 3 (4)