Guidelines For Cleaning The Waterbath - Teledyne VISION G2 CLASSIC 6 User Manual

Vision G2 Testers User Guide—74-108-800 Rev. H—12 June 2019
Connect the drain hose to the heater output.
Go to the Temperature Setpoint screen and touch the PUMP
button.
When the bath is completely drained, touch the PUMP button
again to stop the pump.

Guidelines for Cleaning the Waterbath

This section provides only guidelines for cleaning the
waterbaths of the Classic 6 and Elite 8.
1. Use only a soft cloth when wiping down the
waterbath. Coarse materials may scratch the bath
material.
2. Use only warm water when cleaning the bath or at
any other time.
WARNING: The use of chemicals may damage the waterbath
and will not be covered by the warranty. Clearbath will damage
PETG.
The bath can be cleaned in place or removed for cleaning.
a. The vessel rings should be removed when
removing the bath for cleaning.
b. For the Elite 8, the bulkhead fitting on the side
of the bath must be removed in order to
remove the bath.
Installation
35 of 158