Vision Heater Installation - Teledyne VISION G2 CLASSIC 6 User Manual

Vision G2 Testers User Guide—74-108-800 Rev. H—12 June 2019

Vision Heater Installation

1. Place the Vision heater to the right rear side of the
tester.
2. Connect the tubing as shown in figure C-6 or C-7.
3. Ensure hose clamps are on straight. Tighten the
clamps 3 to 5 clicks to prevent leaks.
NOTE: A pair of pliers is required for proper
tightening of the hose clamps.
4. Connect the tester to the heater by plugging an RS-
232 cable into the Temp Control ports on the tester
and heater.
Installation
29 of 158