Liquid Line Connections; Security - Teledyne VISION G2 CLASSIC 6 User Manual

Vision G2 Testers User Guide—74-108-800 Rev. H—12 June 2019

Liquid Line Connections

Sample line connections are made by connecting the six or
eight liquid tubes from the Vision AutoPlus/AutoFill or other
autosampler to the dissolution tester. These are numbered and
color-coded for easy identification. They can be connected with
nuts, unions, and ferrules as shown in the figure below:
NUT
UNION
Position
1
2
3
4
5
6
7
8
Fig. C-12 Liquid Line Connections

Security

The Vision tester can be configured to require users to log in
and allows for tracking of any changes made to the protocol.
The security system allows for 25 users when using firmware
versions below 2.50 and 50 users for versions 2.50 and above.
Firmware versions below 2.70 offer two levels of users
(managers and operators) with fixed permissions:

Managers are given full access to the unit and allowed to
make any changes to the system as required, with all
these changes being tracked by the software. All users
can be configured as managers for full control of the
Vision tester. One manager is required by the software.
Hanson is installed as a manager from the factory. The
default password for the Hanson manager is 0000.

Operators are permitted to run tests but are not allowed to
make changes to protocols or other system settings. Not
all users can be configured as operators; the software
requires at least one user be configured as a manager.
Installation
FERRULE
Fitting Color
Black
Red
White
Yellow
Green
Blue
Clear
Purple
41 of 158