Table of Contents
Advertisement
Vision G2 Testers User Guide—74-108-800 Rev. H—12 June 2019
Draining the Waterbath (not required for installation)
WARNING: Do not set a temperature during this process. Doing
so may result in damage to the Vision heater.
1.
Remove a vessel over the bath output fitting.
2.
Insert the drain plug into the bath output fitting. This
will allow the bath to drain completely.
Fig. C-10 Drain plug in the bath output fitting (viewed from
above)
Fig. C-11 Drain plug in bath output fitting (viewed from the side)
Installation
34 of 158
Advertisement
Table of Contents
Troubleshooting
