EAW UMX.96 Owner's Manual
• Main to Monitor — Routes the signals from the Left, Right, Center/Mono outputs into the monitor signal
path when no channels are soloed. This routing includes the phones. You can use this button (disengage
it) to silence the phones when nothing is soloed, which may be useful if you are working in a quiet envi-
ronment in close proximity to the audience.
12.9.3
Tone / Noise Generator Tab
This screen controls the internal tone/noise generator. You can select white noise, pink noise, or sine waves
at 100 Hz, 1 kHz, 10 kHz, and 440 (A-440 Hz).
The generator does not have its own output so you must route it somewhere to deliver the signal to a con-
nector on the rear panel.
The selected signal can be routed via the on-screen buttons to Aux/Group outputs 1-24, Matrix outputs 1-8,
Left, Right and/or C/Mono. An on-screen gain control adjusts the generator output and is adjustable via
touch and spin.
The ACTIVE button enables the generator output.
12-76
Touchscreen Interface