Table of Contents
Advertisement
EAW UMX.96 Owner's Manual
12.5.1.6
System Processor Input Delay
Touch the Delay button to access the delay screen. The LED below the Delay button indicates when the
delay is enabled.
The delay provides 0-700 milliseconds of delay in increments of 0.5 ms. The delay interval can be entered as
time or distance via Touch and Spin. The distance in either metric or imperial units and the conversion takes
the ambient temperature into account. Set them both at Setup>General.
This delay is designed for Zone processing (bringing the individual zones in a venue into alignment) and
Array processing (aligning the overall components in an array). The delay is not specifically designed for Box
alignment (aligning the components in an enclosure), which usually requires much finer delay resolution.
For that application, use the manufacturer's recommended crossover/processor.
12.5.1.7
System Processor Output
The system Processor Output routing has two viewing modes:
• Standard Routing View
• Advanced Routing View
Standard Routing View is shown above. It visually indicates input legs routed to output legs as colored
circles connected by colored lines. Each input leg can be routed to any output leg. Output legs begin with a
no way, 2 way, 3 way, or 4 way crossover.
12-55
Touchscreen Interface
Advertisement
Table of Contents
