16
Starting the router
Before you connect the router to a network or a PC, make sure that the router is properly connected to the
power supply. Otherwise, other devices may be damaged.
1. Connect the equipotential bonding to the grounding screw on the top side of the router.
Note that the grounding screw and the device housing with the 0 V potential of the power supply are
electrically connected to terminal X1.
2. Connect the power supply (10-30 V DC) to terminals X1 of the router.
Ensure polarity is correct!
3. Now, switch on the power supply.
° After switching on the power supply, the PwrLED is permanently lit.
° After about 90-120 seconds (depending on the device type), the Rdy LED is permanently lit.
4. The mbNET is now ready for operation.
You can obtain further information about the mbNET industrial router and support on our homepage in the
Support-Forum at
www.mbconnectline.com
NO T I CE
galvanically isolated
NO TI CE
TI P
Starting the router | Page 37 of 324