MB Connect Line mbNET.rokey RKH 210 Manual page 120

Designation
Dialin enable
PPP Server IP-Address
(here)
PPP Client IP address
Authentication via PAP Check box for enabling/disabling this function.
Authentication using
CHAP
Disconnect connection
after [s] inactivity
Dial-in authentication
User name
Password
Page 120 von 324 | V 7.2.0 - en | Aug 25
Description
Check box for enabling/disabling this function.
If the checkbox is enabled, access to the router (mbNET) is approved by a client
computer.
Enter the address of the router (mbNET) here.
You can use the same network domain as the local network. However, you
should avoid using an existing address, as this can lead to an address conflict.
Here, Enter the IP address that the router assigns the client (calling remote ter-
minal) when a PPP connection is established.
The router and the other remote terminal form their own network after the con-
nection.
Accept the factory default setting. PAP is an authentication type. Use the same
setting as the dialling partner.
If PAP is disabled, this authentication will not be accepted, and your data can be
read by others.
Check box for enabling/disabling this function.
Accept the factory default setting. CHAP is an authentication type. Use the
same setting as the dialling partner.
Disabling CHAP has the consequence that this authentication will not be ac-
cepted and your data can be read by others.
Enter the time after which an existing connection is terminated if no data pack-
ets are transmitted during this time.
If nothing is entered, or if the entry is "0", the connection remains active.
Drop-down menu:
• Only the following user
Only the user registered in the following input fields is entitled to dial in to
the router (mbNET).
• Any user with dial-in rights
Every user who has been activated in the User Management > User (sys-
tem) for a "modem dial-up", is entitled to establish a connection.
Enter the username for the PPP dial-in.
Enter the associated password for the PPP dial-in.
th , 2022 |