MB Connect Line mbNET.rokey RKH 210 Manual page 278

• Firewall Settings for Node-Red
Here, you add firewall rules to open ports for Node-RED.
By default, a network socket node in Node-RED has access only from the inside out. Therefore, any
"listener socket" created in Node- RED is not accessible via LAN / WAN. For example, an OPC UA
server can not be reached via LAN / WAN. Unless you release the OPCUA server port here in a fire-
wall rule.
• Enter the port number(s) that you want to enable.
Multiple entries of port numbers must be separated by commas.
Clicking on "Save" temporarily saves the current entries/changes.
Temporary stored settings/changes are saved until a reboot of the router.
Only after you confirm via "Apply Changes", will the changes be applied (activated) and stored permanently.
Page 278 von 324 | V 7.2.0 - en | Aug 25
But the changes are not yet enabled.
Clicking on "Close" discards the current input/changes.
N O T I C E
Clicking on "Apply changes" will apply all stored settings/changes and store them perma-
nently on the router.
"Clear Changes" will reset/discard all temporarily stored settings/changes.
th , 2022 |
NO TI CE