MB Connect Line mbNET.rokey RKH 210 Manual page 29

LED LED LED
colour status
Fc3 orange off
flashes
green off
on
Fc4 orange off
flashes
green off
on
flashes
Rdy orange off
on
green off
flashes
on
Con orange off
on
flashes
green off
flashes
on
Pwr green off
green on
Stat red flashes
on
green on
Operation green on
red on
User 1 -
User 2 -
Description
GSM devices: no reception
GSM devices: Blink frequency 1 Hz == 20 % – 50 % reception quality
• Together with Fc1 if a firmware has been detected via the USB interface.
GSM devices: Reception quality display depends on Fc4
GSM devices: Fc3 green + Fc4 green: 71 % – 100 % reception quality
GSM devices: no reception
GSM devices: Fc4 orange + Fc3 orange): 1Hz == 51 % – 70 % reception quality
GSM devices: Reception quality display depends on Fc3
GSM devices: Fc4 green + Fc3 green: 71 % – 100 % reception quality
During the activation phase of mbEDGE the LED Fc4 flashes at a frequency of 3 Hz
(fast).
After completion of activation at a frequency of 1.5 Hz (slow).
Waiting for bootloader or signature successfully tested
Checks signature, loads kernel
Waiting for kernel
System loading rootFs
Boot process complete, the device can be used.
No VPN connection started
Internet connection is established + VPN connection is started
Blink frequency 1.5 Hz: VPN connection is established
No Internet connection
Blink frequency 3 Hz: Internet connection is started
Internet connection is established
The power supply to the router is interrupted/the router is not connected to the pow-
er supply.
The power supply is connected to the terminal box and switched on.
Error in memory
Error found
The error type can be viewed on the WebGUI of the mbNET under
System> Info> "Last error message".
In conjunction with the mbCONENCT24 portal: User is connected to the device.
For key switch position: OFF / ONL
For key switch position: RST / REM
- Currently without function.
- Currently without function.
Display, controls and connectors | Page 29 of 324