Table of Contents
Advertisement
Designation
Description
Time synchronization
Checkbox for enabling/disabling the NTP function.
using NTP
If this checkbox is activated, the mbNET acts as an NTP client.
Server address
Enter the IP address or the name of the time server (default address: 0.de.pool.nt-
p.org). When entering a name, a DNS server must be entered in the network set-
tings, or you must be connected to the Internet. The NTP server must be easily ac-
cessible.
Update interval (h)
Enter the value for the NTP polling interval (in hours).
Input => natural numbers [hr] > 0.
Run NTP Server for
Checkbox to activate / deactivate the function.
LAN
If this function is activated, the mbNET transfers its local system time via an NTP
server via the LAN interfaces to devices connected to it.
Clicking on "Save" temporarily saves the current entries/changes.
Temporary stored settings/changes are saved until a reboot of the router.
Only after you confirm via "Apply Changes", will the changes be applied (activated) and stored permanently.
When 0 or "blank" is entered, there is no time synchronization.
But the changes are not yet enabled.
Clicking on "Close" discards the current input/changes.
NO T I CE
NO T I CE
System - settings and basic router configuration | Page 65 of 324
Advertisement
Table of Contents
