Initial Configuration Of The Router Via Its Device Web Interface - MB Connect Line mbNET.mini User Manual

12.8 Initial configuration of the router via its device web interface

You can preconfigure the mbNET with its portal connection data (see chapter Firststart).
If the mbNET can establish a connection to the Internet, it logs on to your mbCONNECT24 account with this
data and fetches the configuration it has provided.
Requirement
• The mbNET is ready for operation and can establish a connection to the Internet.
• The connection data in the mbNET are congruent with the connection data that you have stored for this
mbNET in mbCONNECT24.
The data entered in Firststart are only available as long as the mbNET is connected to the supply voltage.
After switching off the supply voltage, all data entered here are lost and must be re-entered after switching
on again.
Do not switch off the mbNET until the mbNET has picked up its configuration from the
portal.
Connect the mbNET.mini to the power supply.
Connect the mbNET.mini via one of the LAN interfaces to the Ethernet interface on your configuration PC.
The configuration PC and the mbNET.mini must be in the IP address range (192.168.0.X).
For this purpose, where necessary, carry out the following settings on your computer:
The mbNET.mini is shipped with the IP address
192.168.0.100. You must therefore assign the same
address range to your computer. This applies for the
IP address as well as for the subnet mask.
To do this, open the properties for your LAN connec-
tion. You can set your computer's IP address under
the properties for the Internet protocol (TCP/IP).
Your computer's IP address must be in the address
range "192.168.0.X", the subnet mask must be identi-
cal to that of the mbNET.mini (255.255.255.0).
Page 68 von 131 | Version: 2.2.1 - EN | Mar 28
NO T I CE
NO T I CE
th , 2022 |
mbCONNECT24