MB Connect Line mbNET.rokey RKH 210 Manual page 232

(Authentication procedure = X.509 - client mode)
If one of the following options was selected for "Link connection", this mbNET is in client mode and is referred
to as "Client".
- Connection immediately
- Start with an active internet connection
- Connect when input 1 has High-signal
- Connect when input 2 has High-signal
- Connect when input 3 has High-signal
- Connect when input 4 has High-signal
- Connect when input 1 has High-signal, disconnect at Low-Signal
- Connect when input 2 has High-signal, disconnect at Low-Signal
- Connect when input 3 has High-signal, disconnect at Low-Signal
- Connect when input 4 has High-signal, disconnect at Low-Signal
- Connect while pushing "Dial Out" button
In this case, the router on the opposite side is in "waiting position".
NO T I CE
For this authentication method, you must first create/import your certificates (see:"System > Certificates").
Page 232 von 324 | V 7.2.0 - en | Aug 25 th , 2022 |