Com2 Network Settings - MB Connect Line mbNET.rokey RKH 210 Manual

25.3.2 COM2 Network settings

Designation Description
Protocol Select the appropriate driver for your connected devices.
Port Enter the port via which the communication should take place here.
Enable ports in If this checkbox is enabled, the port indicated above is enabled for direct access from
the firewall the Internet in the firewall.
Lock service Check box for enabling/disabling this function.
If this function is enabled, the serial driver to communicate between mb-
DIALUP/VCOM-LAN and serial port is not started.
Clicking on "Save" temporarily saves the current entries/changes.
Temporary stored settings/changes are saved until a reboot of the router.
Only after you confirm via "Apply Changes", will the changes be applied (activated) and stored permanently.
Page 164 von 324 | V 7.2.0 - en | Aug 25
But the changes are not yet enabled.
Clicking on "Close" discards the current input/changes.
NO T I CE
th , 2022 |