Victoria Arduino Eagle One Prima Service Manual page 13

Simonelli Group is not responsible for
damages caused by failure to comply
with this prohibition.
During installation, the mains power
system needs to be equipped with a
disconnector switch to cut-off each
phase.
In case of fire, disconnect power to
the machine by turning OFF the main
switch. Its absolutely avoid to extin-
guish the fire with water while power to
the machine is ON.
Should it be necessary to replace the
power cord, this replacement operation
must only be performed by an author-
ized service centre or by the manufac-
turer.
Before servicing the appliance, the
authorised technician must switch OFF
the appliance and unplug it first.
05 05
For all cleaning operations, comply
exclusively with the instructions given
in this booklet manual.
06 06
M M M A A A C C C H H H IN N N E E E
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
D D D E E E S S S C C C R I R R I P P P T T T IO O O N N
In case of breakdown or wrong func-
tioning of the machine, switch it OFF.
Any intervention is strictly forbidden.
Contact qualified experts only.
Repairs should only be made by the
manufacturer or authorized service
centres. Use only original spare parts.
Non-compliance with the above stat-
ed can compromise the safety of the
machine.
During installation, the licensed electri-
cian shall provide an omni-polar switch
as per the applicable safety standard
with opening distance of the contacts,
which allows the complete disconnec-
tion in the conditions in the overvoltage
category III. For Australia, the above
must be done according to the AS/NZS
3000 installation standard.
To avoid dangerous overheating, make
sure the supply cord is fully uncoiled.
Do not obstruct the extraction and/or
dissipator grids, especially of the cup
holder surface.
07 07
To support the aeration of the machine,
place it with a distance of 100 mm from
the walls or from other machines on the
aeration side.
01
13