Removable Media Devices; Figure 4-5. Removing The Cd Drive Bay's Rear Cover - HP Vizualize,Visualize b2000 Supplementary Manual

Removable Media Devices

There are only two removable media devices allowed in a B2000 workstation:
• CD drive (standard component)
• 3.5-inch floppy disk drive (optional component)
The procedures in the following subsections explain how to remove and replace (install)
these removable media devices.
Removing and Replacing a CD Drive
WARNING Power off the workstation and unplug the power cord before
removing and replacing (installing) a CD drive.
CAUTION CD drives are susceptible to mechanical and electrostatic shock. When
handling the drive, always wear the static-grounding wrist strap that came in
the CD drive kit. Always handle the drive carefully.
Perform the following steps to remove and replace a CD drive:
1. Open the front and left side panels of the workstation as shown in the sections
"Opening the Front Panel" and "Opening the Left Side Panel."
2. Remove the rear cover of the CD drive bay inside the workstation by unscrewing the
T-15 Torx/slotted screw as shown in Figure 4-5. Push the cover handle toward the rear
of the CD drive approximately one inch, and then pull the cover handle toward you.

Figure 4-5. Removing the CD Drive Bay's Rear Cover

Rear
Cover
Audio
Cable
ATAPI Cable
3. Disconect the audio, ATAPI, and power cables from the rear of the CD drive.
Chapter 4
Rear Cover
Handle
Power Cable
Field Replaceable Units
FRU Removal and Replacement
T-15
Torx/Slotted
Screw
91