Procedure (Open Systems Mode); Configure Ports Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Procedure (open systems mode)

To configure ports in open systems mode, use the following steps:
1. Select Ports from the Configure menu on the menu bar.
The Configure Ports dialog box displays.
Figure 3–4: Configure Ports dialog box
Ports are numbered from 0 through 23.
2. Click a Name field and type a name that reflects the end device connected through
the port. For example, use "XYZ Server," where XYZ is the brand name of the
server.
3. Block or unblock operation for a port by clicking the check box in the Blocked
column. When a check mark displays, the port is blocked.
4. Enable or disable LIN alerts for the port by clicking the check box in the LIN
Alerts column. When a check mark displays, LIN alerts are enabled.
NOTE: The factory default for LIN alerts is enabled.
5. Click the check box in the FAN column to enable Fabric Address Notification for
loop devices.
edge switch 2/24 product manager user guide
Configuring the Switch
3–11