Meter Setting And Adjustment - Toshiba TOSVERT VF-FS1 Instruction Manual

5.4

Meter setting and adjustment

•
Function
The signal output from the FM terminal is an analog voltage signal.
For the meter, use either a full-scale 0-1mAdc ammeter or full-scale 0-7.5Vdc (or 10Vdc-1mA) voltmeter.
Switching to 0-20mAdc (4-20mAdc) output current can be made by turning the FM (SW2) slide switch to
the I position. When switching to 4-20mAdc current input, make adjustments using
output gradient) and
[Parameter setting]
Title
5
: Meter selection
: Meter adjustment
(analog output bias).
Function Adjustment range
0: Output frequency
1: Output current
2: Set frequency
3: DC voltage
4: Output voltage command value
5: Input power
6: Output power
7: Torque
8: Torque current
9: Motor cumulative load factor
Meter 10: Inverter cumulative load factor
selection 11: - (Do not select)
12: Frequency setting value (after PID)
13: VIA Input value
14: VIB Input value
15: Fixed output 1 (Output current: 100%)
16: Fixed output 2 (Output current: 50%)
17: Fixed output 3
(Supposition output at
18: Serial communication data
19: For adjustments (
displayed.)
Meter
-
adjustment
Supposition output at
Maximum frequency (
1.5 times of rated current
Maximum frequency (
1.5 times of rated voltage
1.5 times of rated voltage
1.85 times of rated power
1.85 times of rated power
2.5 times of rated torque
2.5 times of rated torque
Rated load factor
Rated load factor
Maximum frequency (
Maximum input value
Maximum input value
=17)
set value is
E-10
E6581381
(analog
Default setting
=
)
)
0
-
)
-
-
-
FA51=1000
-
- -