Simplified Operation Of The Vf-Fs1 - Toshiba TOSVERT VF-FS1 Instruction Manual

3.1

Simplified Operation of the VF-FS1

The procedures for setting operation frequency and the methods of operation can be selected from the following.
Setting the frequency
3
Local mode and Remote mode
LOC
REM
*1 At default setting, the switching between Local mode and Remote mode is effective. When prohibiting this
function, refer to the chapter 6.20.1.
*2 At default setting, when switched from remote of start or stop and running frequency at Remote mode are
shifted to Local mode. When changing from Local mode to Remote mode, the inverter can start in case of
running mode selection at remote side. In case of prohibiting this function. ⇒ See section 6.10.
*3 The status of Local/Remote mode is memoried when power off.
Remote mode selection, use the basic parameters
mode selection),
Title
* See 5.3 for
: (1) Run and stop from the operation panel
Start / Stop
: (1) Setting using the operation panel
Local mode : When Local mode selected by
effective only by operation panel keys.
The LOC/REM key lamp is lit while Local mode selected.
Remote mode : Start and stop, and frequency setting follow the selection of
mode),or
Function
Command mode selection
Frequency setting mode
selection 1
,
.
(2) Run and stop using external signals to the terminal
board
(3) Run and stop through serial communication
(2) Setting using external signals to the terminal board
(0-10Vdc, 4-20mAdc)
(3) Setting through serial communication
(4) Setting using external contact up/down
LOC
key, start and stop, and frequency setting are
REM
(Frequency setting mode).
(Frequency setting mode selection 1).
Adjustment range
0: Terminal board
1: Panel
2:Serial communication
1: VIA
2: VIB
3: Operation panel
4: Serial communication
5: External contact up/down
C-2
E6581381
(Command
(Command
Default setting
0
1