Toshiba TOSVERT VF-FS1 Instruction Manual page 35

• Install surge suppressor on any magnetic contactor and relay coils used around the inverter.
• Install noise filters if necessary.
• Install EMC plate and use shielded wires.
Installing more than one unit in a cabinet
If you are installing two or more inverters in one cabinet, pay attention to the following.
• Inverters may be installed side by side with each other with no space left between them.
• When installing inverters side by side, detach the caution label on the top surface of each inverter and
use them where the ambient temperature will not rise above 40°C.
When using inverters where the ambient temperature will rise above 40°C, leave a space of 5 cm or
more between them and remove the caution label from the top of each inverter, and operate each
inverter at a current lower than the rated one.
• Ensure a space of at least 20 centimeters on the top and bottom of the inverters.
• Install an air deflecting plate so that the heat rising up from the inverter on the bottom does not affect the
inverter on the top.
EMC plate
Ventilation fan
A-23
Inverter
Air deflecting plate
Inverter
E6581381
1