Toshiba TOSVERT VF-FS1 Instruction Manual page 225

Table of output terminal functions 1
Function Code
No.
0 LL Frequency lower limit
1 LLN Inversion of frequency lower limit
2 UL Frequency upper limit
3 ULN Inversion of frequency upper limit
4 LOW Low-speed detection signal
5 LOWN Inversion of low-speed detection signal
6 RCH Designated frequency attainment signal
(completion of acceleration/deceleration)
7 RCHN Inversion of designated frequency attainment
signal (inversion of completion of
acceleration/deceleration)
8 RCHF Set frequency attainment signal
9 RCHFN Inversion of set frequency attainment signal
10 FL Failure signal (trip output)
11 FLN Inversion of failure signal (inversion of trip output)
12 OT Over-torque detection
13 OTN Inversion of over-torque detection
14 RUN Start/Stop
15 RUNN Inversion of RUN/STOP
16 POL OL pre-alarm
17 POLN Inversion of OL pre-alarm
20 POT Over-torque detection pre-alarm
21 POTN Inversion of over-torque detection pre-alarm
22 PAL Pre-alarm
Function
ON: The output frequency is above the
OFF: The output frequency is equal to or less than
Inversion of LL setting
ON: Output frequency is equal to or higher than
OFF: Output frequency is lower than
Inversion of UL setting
ON: Output frequency is equal to or higher than
OFF: Output frequency is lower than
Inversion of LOW setting
ON: The output frequency is equal to or less than
OFF: The output frequency is above the specified
Inversion of RCH setting
ON: The output frequency is equal to or less than
OFF: The output frequency is above the frequency
Inversion of RCHF setting
ON: When inverter is tripped
OFF: When inverter is not tripped
Inversion of FL setting
ON: Torque current is equal to or larger than
OFF: The torque current is equal to or less than
Inversion of OT
ON: When operation frequency is output or during
OFF: Operation stopped
Inversion of RUN setting
ON: 50% or more of calculated value of overload
OFF: Less than 50% of calculated value of
Inversion of POL setting
ON: Torque current is equal to or larger than 70%
OFF: The torque current is below (
Inversion of POT setting
One of the following is turned on:
All the following are turned off:
K-17
E6581381
Action
value.
the set value.
value.
value.
value.
the specified frequency ± frequency set with
.
frequency ± frequency set with
the frequency set with ±
set with ± .
set value and longer than
set time.
( set value - set value).
( )
protection level
overload protection level
of set value.
value x 70% - set value).
ON POL, POT, MOFF, UC, OT, LL stop, COT,
and instantaneous power failure coast stop.
or , , issues an alarm
OFF POL, POT, MOFF, UC, OT, LL stop,
COT, and instantaneous power failure coast
stop.
or , , issues no alarm
set
value.
.
.
11
set