Toshiba TOSVERT VF-FS1 Instruction Manual page 5

Transportation & installation
• Do not install or operate the inverter if it is damaged or any component is missing.
This can result in electric shock or fire. Please consult your local sales agency for repairs.
Call your local sales agency for repairs.
• Do not place any inflammable objects nearby.
Prohibited
If a flame is emitted due to malfunction, it may result in a fire.
• Do not install in any location where the inverter could come into contact with water or
other fluids.
This can result in electric shock or fire.
• Must be used in the environmental conditions prescribed in the instruction manual.
Use under any other conditions may result in malfunction.
• Mount the inverter on a metal plate.
The rear panel gets very hot. Do not install in an inflammable object, this can result in fire.
• Do not operate with the front panel cover removed. This can result in electric shock.
Failure to do so can lead to risk of electric shock and can result in death or serious injury.
Mandatory
• An emergency stop device must be installed that fits with system specifications (e.g. shut
off input power then engage mechanical brake). Operation cannot be stopped immediately
by the inverter alone, thus risking an accident or injury.
• All options used must be those specified by Toshiba.
The use of any other option may result in an accident.
• When transporting or carrying, do not hold by the front panel covers.
The covers may come off and the unit will drop out resulting in injury.
• Do not install in any area where the unit would be subject to large amounts of vibration.
Prohibited
That could result in the unit falling, resulting in injury.
• The main unit must be installed on a base that can bear the unit's weight.
If the unit is installed on a base that cannot withstand that weight, the unit may fall
resulting in injury.
• If braking is necessary (to hold motor shaft), install a mechanical brake.
Mandatory
The brake on the inverter will not function as a mechanical hold, and if used for that
purpose, injury may result.
Wiring
• Do not connect input power to the output (motor side) terminals (U/T1,V/T2,W/T3).
That will destroy the inverter and may result in fire.
• Do not connect resistors to the DC terminals (between PA/+ and PC/-).
That may cause a fire.
Prohibited • Within ten minutes after turning off input power, do not touch wires of devices (MCCB)
connected to the input side of the inverter.
That could result in electric shock.
Danger
Warning
Danger
3
E6581381
I
See item
1.4.4
1.4.4
2.
1.4.4
1.4.4
1.4.4
1.4.4
1.4.4
See item
2.
1.4.4
1.4.4
1.4.4
See item
2.2
2.2
2.2