Toshiba TOSVERT VF-FS1 Instruction Manual page 75

<Frequency setting mode selection>
Title Function
Frequency setting mode selection 1
[Programmed value]
:
VIA input
:
VIB input
:
Operation panel
:
Communication
:
UP/DOWN frequency
No matter what value the command mode selection
are set to the control input terminal functions described below are always in operative state.
• Reset terminal (default setting: RES, valid only for tripping)
• Standby terminal (when programmed by programmable input terminal functions).
• External input tripping stop terminal command (when so set using the programmable input terminal
function)
To make changes in the command mode selection
, first stop the inverter temporarily.
Preset-speed operation
: Set to (Terminal board).
: Valid in all setting values.
1: VIA
2: VIB
3: Operation panel
4: Serial communication
5: UP/DOWN from external contact
A frequency command is set by means of a signal from an external input device
(VIA terminal: 0-10Vdc or 4-20mAdc).
An external signal (VIB terminal: 0-10Vdc) is used to specify a frequency
command.
Press the key or the
expansion panel (optional) to set frequency.
Frequencies are set by commands from an external control unit.
Terminals are used to specify an up/down frequency command.
E-9
Adjustment range
key on either the operation panel or the
and the frequency setting mode selection
and the frequency setting mode selection 1
E6581381
Default setting
1
5