Toshiba TOSVERT VF-FS1 Instruction Manual page 32

1
•
Note:
•
•
Operate in areas where ambient temperature ranges from -10°C to 60°C.
When installing the inverter where the ambient temperature will rise above 40°C, remove the label
(seal) from the top and operate it at a current lower than the rated one.
The inverter is a heat-emitting body. Make sure proper space and ventilation is provided when
installing in the cabinet. When installing inside a cabinet, we recommend the top seal peeled off
although 40°C or less.
Do not install in any location that is subject to large amounts of vibration.
If the VF-FS1 Inverter is installed near any of the equipment listed below, provide measures to insure
against errors in operation.
Resistors
•
Do not install in any location of high temperature, high humidity,
moisture condensation and freezing and avoid locations where
there is exposure to water and/or where there may be large
amounts of dust, metallic fragments and oil mist.
•
Do not install in any location where corrosive gases or grinding
fluids are present.
5cm
5cm
Measurement position
5cm
Measurement position
Note: If the VF-FS1 Inverter is installed in a location that is subject
to vibration, anti-vibration measures are required. Please
consult with Toshiba about these measures.
Solenoids:
Brakes:
Magnetic contactors: Attach surge suppressor on coil.
Fluorescent lights:
Resistors:
A-20
E6581381
Attach surge suppressor on coil.
Attach surge suppressor on coil.
Attach surge suppressor on coil.
Place far away from VF-FS1 Inverter.