Toshiba TOSVERT VF-FS1 Instruction Manual page 192

(Continued)
Note:
8.2.2
At the occurrence of a trip, the same information as that displayed in the mode described in 8.1.1, "Status monitor
under normal conditions," can be displayed, as shown in the table below, if the inverter is not turned off or reset.
To display trip information after turning off or resetting the inverter, follow the steps described in 8.1.2, "Display of
8
detailed information on a past trip."
Example of call-up of trip information
Item displayed
Cause of trip
Parameter setting
mode
Direction of
rotation
Operation
Note 1
frequency
command
Note 2
Load current
Note 3
Input voltage
Output voltage
(Continued overleaf)
Failure
Error code
code
0026
0027
0054
0029
002E
0032
0033
0034
0035
002F
Past trip records (trip records retained or trips that occurred in the past) can be called up.
⇒ See section 8.1 "Status monitor mode" for the call-up procedure.
(*) Strictly speaking, this code is not an error code; this code is displayed to show the absence of error
when the past trip monitor mode is selected.
Display of trip information at the occurrence of a trip
Key
operated display
MODE
MODE
Overcurrent flowing in element during deceleration
Overcurrent flowing in element during constant-speed operation
Auto-tuning error
Inverter type error
External thermal input
VIA cable break
Communication error between CPUs
V/F control error
CPU fault 2
Step-out (for PM motors only)
LED
Communic
ation No.
Status monitor mode (The code blinks if a trip
occurs.)
The motor coasts and comes to a stop (coast stop).
The first basic parameter "
is displayed.
The direction of rotation at the occurence of a trip
FE01 is displayed. (
reverser run).
The operation frequency command value (Hz/free
FE02 unit) at the occurrence of a trip is displayed.
The output power of the inverter at the occurrence
FE03
of a trip (%/A) is displayed.
The inverter input (DC) voltage (%/V) at the
FE04
occurrence of a trip is displayed.
The output voltage of the inverter at the
FE05
occurrence of a trip (%/V) is displayed.
H-6
Description
Description
" (Wizard function)
: forward run,
E6581381
: