Toshiba TOSVERT VF-FS1 Instruction Manual page 175

The following are available as common serial optional units:
• USB communication conversion unit (Model: USB001Z)
Communication cable (Model: CAB0011 (1m), CAB0013 (3m), CAB0015 (5m))
• Internal LonWorks
® communication circuit board (Model: ILU007Z)
• Internal BACnet
® communication circuit board (Model: BCN002Z)
• Internal Metasys
® N2 communication circuit board (Model: MTS002Z)
• Internal Siemens APOGEE
These internal products require no interconnect cables, because of built-in type.
Communication function parameters (Common serial options)
The data transfer speed, parity type, inverter number, and communication error trip time can be set/edited by
operation panel operation or communication function.
Title Function
Communication rate
Parity
Inverter number
Communication error trip time
Communication waiting time
Setting of master and slave
for communication between
inverters
Communication command point 1
setting
Communication command point 1
frequency
Communication command point 2
setting
Communication command point 2
frequency
Selection of communication
protocol
TM FLN communication circuit board (Model: APG002Z)
0: 9600bps
1: 19200bps
0: NON (No parity)
1: EVEN (Even parity)
2: ODD (Odd parity)
0-247
0: Disabled (*)
1-100 (s)
0.00: Regular communication
0.01-2.00 (s)
0: Slave (0 Hz command issued in
case the master inverter fails)
1: Slave (Operation continued in
case the master inverter fails)
2: Slave (Emergency stop tripping
in case the master inverter fails)
3: Master (transmission of
frequency commands)
4: Master (transmission of output
frequency signals)
0-100 (%)
0-200.0 (Hz)
0-100 (%)
0.0-200.0 (Hz)
0: Toshiba inverter protocol
1: ModbusRTU protocol
2: Metasys N2 protocol
3: APOGEE FLN protocol
4: BAC-net protocol
F-79
Adjustment range
E6581381
Default setting
1
1
0
6
0
0.00
0
0
0.0
100
50.0 (WP type)
60.0 (WN type)
0