Toshiba TOSVERT VF-FS1 Instruction Manual page 64

4.2.6
For safety reasons, the following parameters have been set up so that they cannot be reprogrammed while
the inverter is running. Stop operation ("
[Basic parameters]
4
[Extended parameters]
The setting of any parameter other than the above can be changed even during operation.
Keep in mind, however, that when the parameter
(prohibited), no parameters can be set or changed.
Parameters that cannot be changed while running
: Automatic acceleration/deceleration
: Parameter setting macro function
: Command mode selection
: Frequency setting mode selection 1
: Default setting
: Maximum frequency
: Base frequency 1
: Base frequency voltage1
: V/F control mode selection 1
∼
: Input terminal selection parameters
∼
: Output terminal selection parameters
: Base frequency 2
: Base frequency voltage 2
∼
: Protection parameters
: Carrier frequency control mode selection
: Auto-tuning
∼
: Motor constant parameters
∼
: Motor control parameters
: Stall prevention level 1
: Emergency stop selection
: Output phase failure detection mode selection
: Input phase failure detection mode selection
: Detection of output short-circuit during start-up selection
: Over-voltage stall protection level
: Under voltage trip/alarm selection
: Prohibition of panel local/remote operation (
∼
: PM motor parameters
" or " " is displayed) before changing parameter settings.
Set
the inverter is running.
LOC
key)
REM
(prohibition of change of parameter settings) is set to
D-10
E6581381
, and they can be changed while