Toshiba TOSVERT VF-FS1 Instruction Manual page 49

3.1.1 How to start and stop
Example of a
Key operated LED display
MODE
ENT
⇔
ENT
(1) Start and stop using the operation panel keys (
Use the and
STOP
RUN
: Motor starts.
RUN
To switch between forward run and reverse run from the control panel, the parameter
(forward/reverse run selection) needs to be set to
(2) RUN/STOP by means of an external signal to the terminal board (
Sink (Negative) logic
Use external signals to the inverter terminal board to start and stop the motor.
Short and
F CC
Open and
F CC
(3) Coast stop
The standard default setting is for slowdown stop. To
make a coast stop, assign a "1(ST)" terminal function
to an idle terminal using the programmable terminal
function.
Change to = .
For coast stop, open the ST-CC when stopping the
motor in the state described at left.The monitor on the
inverter at this time will display
setting procedure
Displays the operation frequency (operation stopped).
(When standard monitor display selection
frequency])
Displays the first basic parameter [Wizard function (
Press either the or
Press ENT key to display the parameter setting. (Default setting: ).
Change the parameter to
Press the ENT key to save the changed parameter.
parameter set value are displayed alternately.
keys on the operation panel to start and stop the motor.
: Motor stops.
STOP
terminals: run forward
terminals: slow down and stop
.
C-3
Operation
=  [Operation
key to select " ".
(panel) by pressing the
= )
or .
Frequency
F-CC
Motor
speed
F-CC
ST-CC
E6581381
)].
3
key.
and the
= ):
Slow down
and stop
ON
OFF
Coast stop
ON
OFF
ON
OFF