Dip Switch Sw3 For Boot Configuration - Kontron CP6003-RA/RC User Manual

Configuration
Table 4-3:

DIP Switch SW3 for Boot Configuration

SWITCH SETTING
1
2
3
4
The default settings of the DIP switch SW3 are indicated by using italic bold.
Note ...
If the DIP switch SW3, switch 2, is set to ON, the SPI boot flash selection can-
not be overwritten by the IPMI controller.
To clear the uEFI BIOS settings, proceed as follows:
1. Set the DIP Switch SW3, switch 4, to the ON position.
2. Apply power to the system.
3. After 30 seconds, remove power from the system.
During this time period of approx. 30 seconds, no messages are displayed.
4. Set the DIP Switch SW3, switch 4 to the OFF position.
Page 4 - 4
OFF Boot-up with POST Code indication on the Debug LEDs
ON Boot-up with no POST Code indication on the Debug LEDs
OFF Boot from the standard SPI boot flash
ON Boot from the recovery SPI boot flash
OFF Reserved
ON
OFF Boot using the currently saved uEFI BIOS settings
ON Clear the uEFI BIOS settings and use the default values
CP6003-RA/RC
DESCRIPTION
ID 1046-3890, Rev. 1.0