Table of Contents
Advertisement
Functional Description
Figure 2-4: GbE Connectors
J10, J11 and J12
8
J12
GbE C
1
8
J11
GbE B
1
8
J10
GbE A
1
Ethernet LED Status
ACT (green): This LED monitors network connection and activity. When this LED is lit, it means
that a link has been established. The LED blinks when network packets are sent or received
through the RJ-45 port. When this LED is not lit, there is no link established.
SPEED (green/orange/off): This LED lights up to indicate a successful 100Base-TX or
1000Base-T connection. When green it indicates a 100Base-TX connection and when orange
it indicates a 1000Base-TX connection. When not lit and the ACT LED is active, the connection
is operating at 10Base-T.
2.10.8
Serial ATA Interface
The CP6003-RA/RC provides five Serial ATA (SATA) interfaces with RAID support, one inter-
face is implemented as onboard SATA connector and four SATA interfaces are available only
on the rear I/O. The onboard SATA connector, J19, is used for mounting the SATA Flash mod-
ule. All five SATA ports provide high-performance RAID 0/1/5/10 functionality.
2.10.9
GPI and GPO Signals
The CP6003-RA/RC provides four general purpose inputs (GPI) and four general purpose out-
puts (GPO) on the rear I/O CompactPCI interface.
Page 2 - 16
Table 2-15: Pinout of GbE Con. J10, J11 and J12
MDI / STANDARD ETHERNET CABLE
PIN
10BASE-T
I/O
SIGNAL
1
O
TX+
2
O
TX-
3
I
RX+
4
-
-
5
-
-
6
I
RX-
7
-
-
8
-
-
CP6003-RA/RC
100BASE-TX
1000BASE-T
I/O
SIGNAL
I/O
SIGNAL
O
TX+
I/O
O
TX-
I/O
I
RX+
I/O
-
-
I/O
-
-
I/O
I
RX-
I/O
-
-
I/O
-
-
I/O
ID 1046-3890, Rev. 1.0
BI_DA+
BI_DA-
BI_DB+
BI_DC+
BI_DC-
BI_DB-
BI_DD+
BI_DD-
Advertisement
Table of Contents
