Installation
3.3.5
CCPMC/Conduction-Cooled XMC Module Installation
The CP6003-RA supports the installation of a CCPMC module via the connectors J15 to J18
or a conduction-cooled XMC module via the connector J14.
For the initial installation and standard removal of all CCPMC/conduction-cooled XMC
modules, refer to the documentation provided with the module.
Prior to installation or removal, ensure that the safety requirements indicated in Chapter 3.1 of
this user guide are observed. Particular attention must be paid to the warning regarding the
heat sink!
3.4
Software Installation
Installation of an operating system is a function of the OS software and is not addressed in this
manual. Refer to appropriate OS software documentation for installation.
Note ...
Users working with pre-configured operating system installation images for
plug-and-play-compliant operating systems, such as Windows®, must take into
consideration that the stepping and revision ID of the chipset and/or other on-
board PCI devices may change. Thus, a re-configuration of the operating sys-
tem installation image deployed for a previous chipset stepping or revision ID is
in most cases required. The corresponding operating system will detect new
devices according to the plug-and-play configuration rules.
Page 3 - 16
CP6003-RA/RC
ID 1046-3890, Rev. 1.0