Table of Contents
Advertisement
CP6003-RA/RC
2.10.7
Gigabit Ethernet
The CP6003-RA board provides five 10Base-T/100Base-TX/1000Base-T Ethernet interfaces.
They are based on one Intel® 82580EB Quad Gigabit Ethernet controller and one Intel®
82579LM Gigabit Ethernet controller. The Intel® 82580EB Quad Gigabit Ethernet controller
provides four Gigabit Ethernet interfaces, two on the front panel, GbE A and GbE B, config-
urable to rear I/O (LPc and LPd), and two on the rear I/O, PICMG 2.16 LPa and PICMG 2.16
LPb. The Intel® 82579LM Gigabit Ethernet controller provides one Gigabit Ethernet interface
on the front panel, GbE C.
The CP6003-RC board provides four 10Base-T/100Base-TX/1000Base-T Ethernet interfaces.
They are based on the Intel® 82580EB Quad Gigabit Ethernet controller which provides four
Gigabit Ethernet interfaces on the rear I/O, PICMG 2.16 LPa, PICMG 2.16 LPb, LPc and LPd.
The Boot from LAN feature is supported on the CP6003-RA/RC.
The following table indicates the Gigabit Ethernet port mapping of the CP6003-RA/RC
Table 2-14: Gigabit Ethernet Port Mapping
ETHERNET CONTROLLER
Intel® 82580EB, port 0
Intel® 82580EB, port 1
Intel® 82580EB, port 2
Intel® 82580EB, port 3
Intel® 82579LM
The J10, J11 and J12 Ethernet connectors on the front panel of the CP6003-RA are realized
as RJ-45 connectors. The interfaces provide automatic detection and switching between
10Base-T, 100Base-TX and 1000Base-T data transmission (Auto-Negotiation). Auto-wire
switching for crossed cables is also supported (Auto MDI-X).
ID 1046-3890, Rev. 1.0
Rear I/O port PICMG 2.16 LPb
Rear I/O port PICMG 2.16 LPa
CP6003-RA: front I/O connector J10 (GbE A) or Rear I/O port LPc
CP6003-RC: Rear I/O port LPc
CP6003-RA: front I/O connector J11 (GbE B) or Rear I/O port LPd
CP6003-RC: Rear I/O port LPd
CP6003-RA: front I/O connector J12 (GbE C)
CP6003-RC: not available
Functional Description
PORT MAPPING
.
Page 2 - 15
Advertisement
Table of Contents
