Table of Contents
Advertisement
Introduction
1.8
Standards
The CP6003-RA/RC complies with the requirements of the following standards:
Table 1-3:
Standards for the CP6003-RA
TYPE
CE
Emission
Immission
Electrical Safety
Mechanical
Mechanical Dimensions
Environmental
Climatic Humidity
WEEE
RoHS
Random Vibration
(Broadband)
Single Shock
Note ...
Kontron performs comprehensive environmental testing of its products in accor-
dance with applicable standards.
Customers desiring to perform further environmental testing of Kontron prod-
ucts must contact Kontron for assistance prior to performing any such testing.
This is necessary, as it is possible that environmental testing can be destructive
when not performed in accordance with the applicable specifications.
In particular, for example, boards without conformal coating must not be
exposed to a change of temperature exceeding 1K/minute, averaged over a
period of not more than five minutes. Otherwise, condensation may cause irre-
versible damage, especially when the board is powered up again.
Kontron does not accept any responsibility for damage to products resulting
from destructive environmental testing.
Page 1 - 20
ASPECT
STANDARD
EN55022
EN61000-6-3
EN55024
EN61000-6-2
EN60950-1
IEEE1101.10
IEC60068-2-78
Directive
2002/96/EC
Directive
2002/95/EC
ANSI / VITA 47
(Class V2)
ANSI / VITA 47
(Class OS1)
CP6003-RA/RC
REMARKS
--
--
--
--
93% RH at 40°C, non-condensing
See note below.
Waste electrical and electronic equipment
Restriction of the use of certain hazardous sub-
stances in electrical and electronic equipment
Test parameters:
• 5-100 (Hz) frequency range: +3dB slope
• 100-1000 (Hz) freq. range: 0.04 (g²/Hz)
• 1000-2000 (Hz) freq. range: -6dB slope
• 7.619 g (rms)
• 60 (min) test duration/axis
• 3 axes
Test parameters:
• 20 (g) acceleration
• 11 (ms) shock duration half sine
• 3 shocks per direction
• 6 directions
• 5 (s) recovery time
ID 1046-3890, Rev. 1.0
Advertisement
Table of Contents
