Configuration Resistors (Cp6003-Rc); Configuration Resistors; Configuration Resistors' Settings - Kontron CP6003-RA/RC User Manual

CP6003-RA/RC
4.2

Configuration Resistors (CP6003-RC)

The CP6003-RC is equipped with four configuration resistors, R756, R759, R771, and R778,
used for uEFI BIOS boot configuration.
Figure 4-2: Configuration Resistors (CP6003-RC)
Table 4-4:

Configuration Resistors' Settings

RESISTOR SETTING
R756
R759
R771
R778
The default setting is indicated by using italic bold.
Note ...
If R759 is set to Closed, the SPI boot flash selection cannot be overwritten by
the IPMI controller.
ID 1046-3890, Rev. 1.0
Open Boot-up with POST Code indication on the Debug LEDs
Closed Boot-up with no POST Code indication on the Debug LEDs
Open Boot from the standard SPI boot flash
Closed Boot from the recovery SPI boot flash
Open Reserved
Closed
Open Boot using the currently saved uEFI BIOS settings
Closed Clear the uEFI BIOS settings and use the default values
Configuration
R759 R759
R771 R771
R778 R778 R756 R756
DESCRIPTION
Page 4 - 5