Table of Contents
Advertisement
CP6003-RA/RC
2.10.2
DIP Switches SW1, SW2 and SW3 (CP6003-RA)
The CP6003-RA is equipped with two 2-bit DIP switches, SW1 and SW2, and one 4-bit DIP
switch, SW3, which enable the board to be configured according to the application require-
ments. DIP Switch SW1 is used to configure the CompactPCI interface. DIP Switch SW2 is
used to configure the PMC interface. DIP Switch SW3 is used for uEFI BIOS boot configuration.
Table 2-7:
DIP Switch SW1 Function
SWITCH
1
PCI frequency of the CompactPCI interface
2
PCI/PCI-X mode of the CompactPCI interface
Table 2-8:
DIP Switch SW2 Function
SWITCH
1
PCI/PCI-X frequency multiplier configuration
2
PCI/PCI-X mode of the PMC interface
Table 2-9:
DIP Switch SW3 Function
SWITCH
1
POST Code indication
2
SPI flash boot selection
3
Reserved
4
Clear uEFI BIOS settings
For further information on the configuration of the DIP switches, refer to Chapter 4.1, "DIP
Switches SW1, SW2 and SW3 Configuration".
2.10.3
Configuration Resistors (CP6003-RC)
The CP6003-RC is equipped with four configuration resistors, R756, R759, R771, and R778,
used for uEFI BIOS boot configuration.
Table 2-10: Configuration Resistors
RESISTOR
R756
POST Code indication
R759
SPI flash boot selection
R771
Reserved
R778
Clear uEFI BIOS settings
ID 1046-3890, Rev. 1.0
Functional Description
FUNCTION
FUNCTION
FUNCTION
FUNCTION
Page 2 - 11
Advertisement
Table of Contents
