Table of Contents
Advertisement
3 Conf iguration
3 .1 D I P S w i t ch C o n f i g u r a t i o n
3.1.1 DIP Switch SW1
The DIP switch SW1 serves for general board configuration.
Table 29: DIP Switch SW1 Functionality
SWITCH
SETTING
1
2
3
4
The default setting is indicated by using italic bold.
To clear the uEFI BIOS settings and the passwords, proceed as follows:
1.
Set DIP switch SW1, switch 4, to the ON position.
2.
Apply power to the system.
3.
Wait 30 seconds and then remove power from the system. During this time period no messag-
es are displayed.
4.
Set DIP switch SW1, switch 4, to the OFF position.
3.1.2 DIP Switch SW2
The DIP switch SW2 serves for CompactPCI and PMC PCI interface configuration.
Table 30: DIP Switch SW2 Functionality
SWITCH
SETTING
1
2
3
4
www.kontron.com
OFF
Boot-up with POST code indication on LED3–0
ON
Boot-up with no POST code indication on LED3–0
OFF
Boot from the standard SPI boot flash
ON
Boot from the recover y SPI boot flash
OFF
Non-volatile memory write protection disabled
(if no other write protection sources are enabled)
ON
Non-volatile memory write protection enabled
OFF
Boot using the currently saved uEFI BIOS settings
ON
Clear the uEFI BIOS settings and use the default values
OFF
CompactPCI frequency 33/66 MHz, auto detection via the backplane
ON
CompactPCI frequency conf igured to 33 MHz
OFF
CompactPCI mode (PCI/PCI-X) auto detection via the backplane
ON
CompactPCI interface conf igured to PCI mode
OFF
PMC PCI frequency 33/66 MHz, auto detection via the PMC interface
ON
PMC PCI frequency conf igured to 33 MHz
OFF
Reserved
ON
CP6005(X)-SA
FUNCTIONALIT Y
FUNCTIONALIT Y
User Guide
46
Advertisement
Table of Contents
