Kontron CP6003-RA/RC User Manual page 36

Introduction
Table 1-2: CP6003-RA/RC Main Specifications (Continued)
FEATURES
Serial ATA
Front Panel Connectors
(CP6003-RA)
Onboard Connectors
DIP Switches
(CP6003-RA)
Reset Switch
(CP6003-RA)
Hot Swap Switch
(CP6003-RA)
System LEDs
Ethernet LEDs
(CP6003-RA)
Page 1 - 16
One Serial ATA 6 Gb/s interfaces for:
One onboard SATA 6 Gb/s interface for the Serial ATA Flash module (up
•
to 32 GB flash memory)
Four SATA 3 Gb/s ports accessible via rear I/O
DP: one 20-pin DisplayPort connector, J9
•
USB: two 4-pin, type A connectors, J6 and J7
•
Ethernet: three 8-pin, RJ-45 connectors, J10, J11 and J12
•
Serial port: one 8-pin, RJ-45 connector, J8 (COMA)
•
PMC/XMC front panel bezel cutout
•
PMC connectors J15 - J18 (Jn1 - Jn4)
•
XMC connector, J14
•
One 34-pin, SATA extension connector, J19
•
JTAG connector, J20
•
Debug connector, J22
•
XDP-SFF (debug) connector, J24
•
CompactPCI Connectors J1 - J5
•
Three onboard DIP switches, SW1, SW2, and SW3, for board configuration
One front panel hardware reset switch
One switch for hot swap purposes integrated in the front panel handle in
accordance with PICMG 2.1 Rev. 2.0.
System Status LEDs on the CP6003-RA:
I0/I1 (red/green):
•
WD (green):
•
TH (red/green):
•
HS (blue):
•
System Status LEDs on the CP6003-RC:
I0/I1 (red/green):
•
Debug LEDs (CP6003-RA/RC):
DLED0-3 (red/green): Onboard LEDs for debugging purposes
•
Gigabit Ethernet Status:
ACT (green):
•
SPEED (green/orange/off):
•
CP6003-RA/RC
SPECIFICATIONS
Indicate the software status of the IPMI controller
Watchdog Status
Temperature Status
Hot Swap Control
Indicate the software status of the IPMI controller
(located on the rear side of the board)
(located on the rear side of the board)
Ethernet Link/Activity
Ethernet Speed
ID 1046-3890, Rev. 1.0