Dip Switches Sw1, Sw2 And Sw3 Configuration (Cp6003-Ra); Dip Switch Sw1 For Compactpci Interface Configuration; Dip Switch Sw2 For Pmc Interface Configuration; Dip Switches Sw1, Sw2 And Sw3 (Cp6003-Ra) - Kontron CP6003-RA/RC User Manual

CP6003-RA/RC
4. Configuration
4.1

DIP Switches SW1, SW2 and SW3 Configuration (CP6003-RA)

The CP6003-RA is equipped with two 2-bit DIP switches, SW1 and SW2, and one 4-bit DIP
switch, SW3, which enable the board to be configured according to the application require-
ments. DIP Switch SW1 is used to configure the CompactPCI interface. DIP Switch SW2 is
used to configure the PMC interface. DIP Switch SW3 is used for uEFI BIOS boot configuration.
Figure 4-1: DIP Switches SW1, SW2 and SW3 (CP6003-RA)
Table 4-1:

DIP Switch SW1 for CompactPCI Interface Configuration

SWITCH SETTING
1
2
Table 4-2:

DIP Switch SW2 for PMC Interface Configuration

SWITCH
1
2
The default settings of the DIP switches SW1 and SW2 are indicated by using italic bold.
ID 1046-3890, Rev. 1.0
SW1 SW1
OFF PCI 33 MHz / 66 MHz auto detection via the CompactPCI backplane
ON PCI frequency configured to 33 MHz
OFF PCI / PCI-X mode auto detection via the CompactPCI backplane
ON CP6003-RA/RC configured to PCI mode
SETTING
OFF PCI / PCI-X frequency multiplier configured to 33 MHz
ON PCI / PCI-X frequency multiplier configured to 25 MHz
OFF PCI / PCI-X mode auto detection via the PMC module
ON PMC interface configured to PCI mode
Configuration
SW2 SW2 SW3 SW3
DESCRIPTION
DESCRIPTION
Page 4 - 3