Configuration
4.5.10
Board and PLD Revision Register (BREV)
The Board and PLD Revision Register signals to the software when differences in the board
and the Programmable Logic Device (PLD) require different handling by the software. It starts
with the value 0x00 and will be incremented with each change in hardware as development
continues.
Table 4-17: Board and PLD Revision Register (BREV)
REGISTER NAME
ADDRESS
BIT
NAME
7 - 4
BREV
Board revision
3 - 0
PREV
PLD revision
4.5.11
Geographic Addressing Register (GEOAD)
This register holds the CompactPCI geographic address (site number) used to assign the In-
telligent Platform Management Bus (IPMB) address to the CP6003-RA/RC.
Table 4-18: Geographic Addressing Register (GEOAD)
REGISTER NAME
ADDRESS
BIT
NAME
7 - 5
Res.
Reserved
4 - 0
GA
Geographic address
Note ...
The Geographic Addressing Register is set to the default values by power-on
reset, not by warm reset.
Page 4 - 16
BOARD AND PLD REVISION REGISTER (BREV)
0x289
DESCRIPTION
GEOGRAPHIC ADDRESSING REGISTER (GEOAD)
0x28A
DESCRIPTION
CP6003-RA/RC
RESET
ACCESS
VALUE
N/A
R
N/A
R
RESET
ACCESS
VALUE
000
R
N/A
R
ID 1046-3890, Rev. 1.0