Table of Contents
Advertisement
CP6003-RA/RC
2.10
Board Interfaces
2.10.1
Onboard and Front Panel LEDs
The CP6003-RA is equipped with two IPMI LEDs (I0 and I1), one Watchdog Status LED (WD
LED), one Temperature Status LED (TH LED), and one Hot Swap LED (HS LED) on the front
panel and four onboard Debug LEDs (DLED 0..3) located on the rear side of the board.
The CP6003-RC is equipped with two onboard IPMI LEDs and four onboard Debug LEDs
(DLED 0..3) located on the rear side of the board.
The functionality of the Debug LEDs is described in Chapter 2.10.1.3 and reflected in the reg-
isters mentioned in Chapter 4, Configuration.
2.10.1.1
IPMI LEDs and Hot Swap LED
The IPMI LEDs I0 and I1 show the software status of the IPMI controller. The Hot Swap LED
(CP6003-RA) indicates when the board may be extracted. It can be switched on or off by soft-
ware and may be used, for example, to indicate that the shutdown process is finished and the
board is ready for extraction.
The following table indicates the function of the IPMI LEDs and the Hot Swap LED.
Table 2-2:
IPMI LEDs and Hot Swap LED Function
LED
COLOR
I0 (right)
red
green
I1 (left)
red
green
red/amber
HS LED
blue
(CP6003-RA)
ID 1046-3890, Rev. 1.0
NORMAL MODE
Off = board powered / running
On = board out of service (firmware not running)
Pulsing = traffic on the IPMB bus
On = health error detected
Off = no health error detected
Pulsing = KCS interface active
Blinking = IPMI controller running showing its heart beat
Slow blinking = health error detected, IPMI controller run-
ning showing its heart beat
Pulsing = health error detected, KCS interface active
On = a) board ready for hot swap extraction, or
b) board has just been inserted in a powered system
Off = board in normal operation (do not extract the board)
Blinking = board hot swap in progress; board not ready for
extraction
Functional Description
OVERRIDE MODE
Selectable by user
Only lamp test
•
Selectable by user
Only lamp test
•
Selectable by user
Only lamp test
•
Page 2 - 7
Advertisement
Table of Contents
