Dip Switches Sw1, Sw2 And Sw3 Configuration; Dip Switch Sw1 Configuration; Dip Switch Sw1 For Boot Configuration; Dip Switch Sw1 - Kontron CP6003-SA User Manual

CP6003-SA
4. Configuration
4.1

DIP Switches SW1, SW2 and SW3 Configuration

The CP6003-SA is equipped with one 4-bit DIP switch, SW1, and two 2-bit DIP switches, SW2
and SW3, which enable the board to be configured according to the application requirements.
DIP Switch SW1 is used for uEFI BIOS boot configuration. DIP Switch SW2 is used for config-
uring the CompactPCI interface. DIP Switch SW3 is used for configuring the PMC interface.
4.1.1

DIP Switch SW1 Configuration

Figure 4-1: DIP Switch SW1
Table 4-1:

DIP Switch SW1 for Boot Configuration

SWITCH 1 SETTING
1
2
3
4
The default settings of the DIP switches are indicated by using italic bold.
Note ...
If the DIP switch SW1, switch 2, is set to ON, the SPI boot flash selection can-
not be overwritten by the IPMI controller.
ID 1044-9757, Rev. 2.0
OFF Boot-up with POST Code indication on the General Purpose LEDs
ON Boot-up with no POST Code indication on the General Purpose LEDs
OFF Boot from the standard SPI boot flash
ON Boot from the recovery SPI boot flash
OFF Reserved
ON
OFF Boot using the currently saved uEFI BIOS settings
ON Clear the uEFI BIOS settings and use the default values
Configuration
DESCRIPTION
Page 4 - 3