Pmc/Xmc Module Installation; Rear I/O Device Installation - Kontron CP6003-SA User Manual

Installation
3.6

PMC/XMC Module Installation

The CP6003-SA supports the installation of a PMC module via the connectors J21 to J24 or an
XMC module via the connector J20.
For the initial installation and standard removal of all PMC/XMC modules, refer to the
documentation provided with the module.
Prior to installation or removal, ensure that the safety requirements indicated in Chapter 3.1 of
this user guide are observed. Particular attention must be paid to the warning regarding the
heat sink!
Note ...
Only XMC modules with one board-to-board connector (P15) can be used with
the CP6003-SA.
3.6.1

Rear I/O Device Installation

For physical installation of rear I/O devices, refer to the documentation provided with the device
itself.
Note ...
COMA can be used either on the front panel or on rear I/O. It is not possible to
use COMA on the front panel and the rear I/O simultaneously.
Page 3 - 10
CP6003-SA
ID 1044-9757, Rev. 2.0