Upgrade Sx-2000 Light To 3300 Icp Software - Mitel 3300 ICP Hardware User's Manual

3300 ICP Hardware User Guide
Timer: The system takes approximately 20 minutes to restore an average-sized
database, during which time the files are copied to the 3300 Controller. Once the files
have been copied, you must reset the controller. Note that the system can take up to an
additional 1 hour to reset.
Performing maintenance checks
Do not reset any system components (controller, NSU, ASU, DSU, Peripheral Cabinet, and so
on) while executing the following checks.
44. When the system has finished resetting, log back in to ESM (using the customer's user-
name and password).
45. Click System Administration Tool, click Maintenance and Diagnostics, click
Maintenance Commands, then click All.
46. Issue the dbms stat command to check if the DBMS flag (DBMS_INITIALIZED) is ON.
47. Issue the Type*.dr.logfile_1 command to display the log file created during the Data
Restore.
48. Issue the mess sub command to check the programmed NSU links; they should be OPEN.
If any programmed links are in SCAN, check the LINK STATUS LEDs; if the AMBER LEDs
are chasing, this means that the NSUs are writing to the RAM DISK.
Resetting to initialize Voice Mail
49. When the checks are complete, manually reset the controller again to ensure that Voice
Mail is properly initialized.
Note: If additional voice mail ports have been purchased, you should program these first
and then manually reset the controller.
Upgrading IP sets and forcing lease renewals
50. Log back in to ESM and issue the LOAD IPDevice 1 to X (where X represents the last IP
device number) to upgrade the IP phones.
51. If you have an IP console, you must cycle the power on the IP TKB (key pad).
52. If the system has a Legacy Per cab with DNI Line cards, we recommend that you issue
the Load x x x command to load the DNI cards and ensure that the latest DNI line load
is loaded. If you are using internal DHCP, issuing this command will also renew your set
leases and prevent the random resetting of your IP sets when their current lease expires.

Upgrade SX-2000 LIGHT to 3300 ICP Software

• Only one 3300 ICP can be configured at a time; and only one SX-2000 PBX can be migrated
to a 3300 ICP at a time.
• Migration and Configuration cannot be performed in a single task or session using the
3300 Configuration Tool.
• After migration, configuration must be completed using System Administration Tool.
• Data restoration automatically triggers data migration.
• If existing capacity is greater than that of the 3300 ICP, the conversion will fail. See the
capacity table for the 3300 ICP.
202 Release 3.3